View Full Version : 94-98 2nd Gen. 12V
- Please help choose parts for my rebuild
- Problems with 370's
- Another Mahle Piston
- how to get 400 hp
- Broke front cover.
- Injection pump nut torque
- Dana 60 retaining nut size
- New to The Dark Side!!!
- Dampner
- ok a nother problem with truck
- ATI Super Damper
- 12v monster mudder
- help with 2in leveling kit
- head gasket help
- Full throttle stop screw?
- 24v Head on 12v?
- Max PSI for lift pump? Whats safe/optimum?
- 96 12 valve issues
- Valve covers
- turbo in monster mudder takes a dump
- Engine Compression Ratio Calculator
- Where to add breathers?
- Big Oil Leak, Injection Pump?
- 15 inch rims?
- HX-35 and K-31
- hx 40 good or bad
- Hp guesstimations?
- 6.7 turbos any good
- ? on mileage
- sputter at any rpm
- RPM ?s
- how much??
- white haze when cold
- Injectors Leaking??
- 1995 Pcm
- Rearend alignment after axle swap
- Stacks Under Bed!!!
- what is the afc foot
- 4.10s
- TPS mount
- fuel leak
- 33 mpg
- Harmonic Balancer coming loose.
- Help please
- new parts where will i be at?
- Wiring aftermarket accessories......
- DDP injector hole size question...
- Over Sized DV Holders
- Budget Shock Recommendations
- Where To Get a 12V
- Yehaaaw
- Phat Shaft 62/14 - Questions?
- Input please-
- 12V tricks
- Stock Converter Stall Speed
- starwheel
- Tranny question.
- input shaft
- Shifting at higher RPM?
- Hooking Up Fuel Press Guage
- Big brother on a 4WD
- trans problems over drive
- Turbo Help...........
- Which KDP kit?
- Raptor help.
- Spicer Front Axle Ujoint Number?
- aftermarket turbos.....
- fuel problems
- ok guys i need help
- 47re to 47rh?
- head gasket or something else?
- Bad Injector Lines?
- A few questions
- which shafts in trans?
- auto swap
- hooking up a tac on 96 12 valve??
- 3rd gen turbo on a 12v?
- dana 80 cab and chassis width
- pump for 600hp
- Haze at Idle
- Fuel Pressure Gauge
- Problem with converter lock-up
- wacky oil pressure
- dana 80 ring and pinion
- Removing clutch pedal
- Cooling system upgrades?
- Timing questions..
- 2gen Ram rear door glass(window)?
- Throttle valve location?
- Transmission filter bolts?
- Need Tire Correct
- Bad thermostat and tranny safe mode?
- converter unlocking while cruising on highway
- Delivery Valves
- What would you pay for this truck?
- 4k gsk problems
- 97 cummins 60psi and 4000 rpm
- turbo questions
- Thrust bearing wear??
- 47RH questions
- Thinner Injector Washers, More Haze an EGT?
- how long can I run on a scored cylinder?
- New to this part of the forum
- Quick oil drains from Geno's?
- Timing for best mileage?
- 98 12V Body computer PCM / BCM needed!!
- 15" wheels on rear?
- comparing dv`s
- wire questions!!!!!
- injector washers and timing and retorqueing
- Heavy duty parts
- 230 hp motor
- Puller 12v combo Ideas
- fluid capacity?
- Fuel line replacement
- sb clutch
- Installed DDP2, What else to adjust?
- Squeaking noise from speed bump?
- DTT transmission
- 5th gear loss!! help...its not the nut.
- Truck Video Check It Out!
- studs and valves
- no power, no smoke, what to do?
- need help on what combo to build?
- stock lift pump ticking??
- Broken Countershaft!
- Intermittent tach.
- fuel shut off solenoid
- Max EGT's?
- What's the cure for Cruise Control Surge?
- Aftermarket manifold question
- Possible ddp4 problem
- turbo 400 12v
- suggestions?
- I just got a 96 12v for my ford.
- which 2.6/66mm turbo??
- TC Lockup switch.
- 0 plate/turbo questions.
- Basic question
- stock afc spring
- help reaching 600 hp
- Help me identify this part
- Im no electrician
- Different style 2gen headlight and taillight
- manual TC lock-up only
- joke of the day
- harmonic balancer
- mack plug in a 215 pump
- 241LD vs. HD
- aftermarket vavles for 12valves?
- Lowering rear on a 2X4
- Which injectors?
- in-tank fuel filter
- piston
- Fuel Pump Power
- Twins Question
- Help With Twins
- Whats the best 2.6 turbo
- runaway 7100
- truck wont start
- How many MM does a fuel plate move?
- pump or DV problem?
- Whats the best Mahle piston?
- Dumping coolant at back of engine. Sources?
- A/C is DEAD
- Fuel Shutoff Relay
- What fuel plate profile is this???
- Bad Miss whats wrong
- Oil Pan Gasket
- Tranny Shop?
- variations in injection pumps
- valve spring compresser
- TPS testing?
- cam plate adjustment solutions?
- Fuel problem
- S300 vs HX40
- truck is dieing!!!!!!!!!!
- 97 hard start when hot, fine when cold?
- 52PSI Fuel Pressure
- Lift pump option????
- 215 or 175 pump
- Freightliner FL80 Gauge Install Results
- 330s
- New shift knob
- 4Ks VS 3Ks
- '96 Auto Power limitation?
- Temps out or control
- drw to srw...try me
- Miss/Stumble?
- down hill start?
- NV4500 Torque Specs.
- Injector part number question
- pretty sure pumps dead...
- south bend
- twins
- Rear end question for the Dodge experts...
- Phat Shaft 62/14 - Which injectors?
- soften idle
- '98 12v Resto
- 271 swap problem
- Emissions on 12valve
- removing p pump
- Spearco Install
- T-3 spacer plate?
- Transfercase tailhousing....
- 97 auto tranny rebuild problem
- SPS62 or A4000
- FASS Question
- Head Stud help
- help with trans shifting
- Advice on clutch
- 96 dodge problems
- Truck misses and has high egts
- Driveshaft Carrier Bearing Replacement
- What to look for?
- engine sputters and dies under WOT
- afc arm question?
- Monster Pump in a 12v
- Turbo drain hose?
- cyl head torque sequence
- shimming gsk
- no ac bet setup?
- tranny apply lever broke???????????????
- best track bar mod
- Plugged Cat Converter ?
- wont start or even turn over
- Maybe getting back into a 12v
- Governor Tuning Questions
- solid Motors mounts
- how to keep gears still?
- IP Problem??
- Fuel filter housing on ebay????
- 913 pump, where's the v-groove in plunger???
- P7100 IP Max HP
- fuel economy ?
- A Good Tranny shop in Central Texas?
- what is it worth?
- I need 215hp 12v factory injectors
- Newbie with fuel problems, link attached
- 12V swap
- Compound Turbo Questions?
- AFC foot
- water in fuel light
- Dummy vacuum pump??
- off-idle stutter?
- Help, blown head gasket again!!!!!!
- New Tire Time, 315/75/16 questions
- Big brother outlet flange help!
- Valve cover with oil fill hole?
- Getting more fuel out of my 160 pump????
vBulletin® v3.8.7, Copyright ©2000-2024, vBulletin Solutions, Inc.