PDA

View Full Version : Would like a quote on an exhaust housing please...


Extended Power
02-08-2011, 08:31 PM
Looking for a ceramic coated, or stainless steel housing.

-It is for a Borg Warner S300: 64/71/.70 (My existing turbo)

-I am looking for a divided .80 wastegated exhaust housing, with a V-band exit.

PM if preferred.

Thanks!

TopFueler
03-02-2011, 07:37 PM
A coated housing is a very good way to go. It is cheaper by far and is better at heat reflection. I am guessing 350-400. Shane or Brandon can quote you exactly on the price. The stainless housings have been cracking. If you do coatings inside and out side you will never see any cracking. I have not seen any coated housing crack that was coated in and out. Thanks

Extended Power
03-02-2011, 07:56 PM
Thanks.
I just picked up the housing yesterday, and looked at it today...the inlet ports look very small.
I am going to get this one coated inside and out with a titanium finish. (Supposed to be good for over 2000*F) But the color is an army green color.
Getting the S480 coated with a "High Luster" ceramic, inside, and out, that is good for 1200*F.
The hot piping will be done in the 2000*F stuff...the rest will be done in the High luster ceramic.