PDA

View Full Version : R450 Swather


kalder
03-26-2011, 02:14 PM
We are having a problem with the hydro handle.

I want to move the header tilt function to the Honeybee control. The switches are in a circuit board and wired in a matrix fashion. So I can't just switch some pins around in the handle electrical connector.

So, I was trying to figure out if I could build a harness that goes from the Honeybee header command connector, to the tilt valve solenoid.

My problem is I can't find any schematics on the Honeybee connector in Service Advisor. Honeybee has one on their site but doesn't help.

Another question is will my harness work with the CAB controller programmed to the 4.5 meter rotary header? Or will I have to program it to the Honeybee header? If I program it to the Honeybee, will the rotary header function properly?

We have three guys with the same problem, three different machines. It is all operator error, but if I could make it easier for them, it would be awesome.

When they get to the end of a row, and lift the header, they bump the tilt. When they put it down they are swathing dirt.

Thanks in advance!

kalder
03-26-2011, 03:14 PM
http://184.72.239.143/mu/4476d9fc-493a-611d.jpg

kalder
03-26-2011, 03:36 PM
http://184.72.239.143/mu/4476d9fc-4e25-734d.jpg

Oops. I thought the labeling was there

cumminspuller
04-12-2011, 11:27 AM
I wish I could help you man but I'm out on this one. All I could do is speculate.

bosshogg
04-13-2011, 09:27 PM
I'm guessing you have been in touch with DTAC and they have been ZERO help as per usual?

cumminspuller
04-15-2011, 08:48 AM
I'm guessing you have been in touch with DTAC and they have been ZERO help as per usual?

That is 100% true!!

kalder
04-15-2011, 09:02 AM
DTAC is no help here.

bosshogg
04-15-2011, 09:06 PM
I'm betting you are going to wind up pulling that circuit board out of the handle and somehow soldering some jumpers or something in to make the switches do what you are wanting. I want to say there is an address to change in there somewhere but that would be too easy...

kalder
04-17-2011, 03:03 PM
I'm gonna see if the Honeybee connector is active when the CAB module is programmed to the rotary platform. If it is I'm golden.
If not I'll have to get the dealership to buy a $500 hydro handle for me to rework the circuit board.