PDA

View Full Version : Fuel Manifold block


Toolman
05-05-2011, 11:22 AM
This is a fuel manifold block that I made up. It fits the bolt hole pattern on the stock intakes of the CR'S where the fuel filter was located or can be mounted anywhere by drilling your own holes. It has 6- 3/8 NPT tapped holes in it for your fittings. It can be used for incoming fuel going to the injection pumps or for the return lines just to help clean things up in the engine compartment. It also can be rotated on the mounting plate so the fittings can either be vertical or horizontal which ever you prefer.

CSnyder
05-05-2011, 11:27 AM
Nice piece!!!!

Toolman
05-05-2011, 11:39 AM
Thanks Chris