will24
07-06-2013, 02:01 PM
Guys, strange problem...
1972 Deere 4020 side console, syncro, 2 remotes.
I usually run my 10' drill off of the right remote, easier to reach down and grab the outer lever without looking. With all the rain it's been spotty trying to finish up soybeans this year. Last week I went out after the tractor sat 2 days, suddenly the right remote lever is floppy, no "feel" to it except the very end of travel. It's definitely not operating properly either as it's VERY slow to lower the drill.
I swapped to the left side (which is fine), but now I am at a loss. The flow control is turned up to full (rabbit), but I don't see anything mechanically wrong at first glance. It's also very strange that a problem occurred while the tractor was parked...
Any thoughts?
Will
1972 Deere 4020 side console, syncro, 2 remotes.
I usually run my 10' drill off of the right remote, easier to reach down and grab the outer lever without looking. With all the rain it's been spotty trying to finish up soybeans this year. Last week I went out after the tractor sat 2 days, suddenly the right remote lever is floppy, no "feel" to it except the very end of travel. It's definitely not operating properly either as it's VERY slow to lower the drill.
I swapped to the left side (which is fine), but now I am at a loss. The flow control is turned up to full (rabbit), but I don't see anything mechanically wrong at first glance. It's also very strange that a problem occurred while the tractor was parked...
Any thoughts?
Will