Cozze44 Junkman Aug 29, 2013 #1 Thinking of cutting out a section of the engine crossmember to plate it and bolt it in. I'm pretty sure at one time i've seen a thread about someone who has done this, anyone have any experience with this?
Thinking of cutting out a section of the engine crossmember to plate it and bolt it in. I'm pretty sure at one time i've seen a thread about someone who has done this, anyone have any experience with this?
Cozze44 Junkman Aug 30, 2013 #3 All done, slips in and out with the tap of a hammer. I dropped it because the pan i made is a little deeper. Should hd up just fine i think. Attachments ImageUploadedByTapatalk1377916950.841522.jpg 7.7 KB · Views: 0
All done, slips in and out with the tap of a hammer. I dropped it because the pan i made is a little deeper. Should hd up just fine i think.
