PDA

View Full Version : Eas EDGE pressure sensor voltage


steampunk
10-29-2016, 10:12 PM
Im trying to set up an edge pressure sensor (used for boost) to trigger a progressive 2 stage nitrous controller. To set it up i need the pressure at 0.5v and at 4.5v. Ive sent an email to tech support and I'm trying to test and tune tomorrow.

Your help would be greatly appreciated.

biggy238
10-30-2016, 08:50 AM
Does this mean you want to scale the sensors so you can calc read pressure vs Vout?

Sent from my Moto X using Tapatalk

steampunk
10-30-2016, 09:13 AM
Does this mean you want to scale the sensors so you can calc read pressure vs Vout?

Sent from my Moto X using Tapatalk

yes. im guessing the 4.5v would be 100psi.. but is 0.5v atmos or 0psi?

steampunk
10-30-2016, 11:11 AM
Ok so 0.5v is 0psi according to my fluke so I'll scale from .5v to 4.5v as 0 to100psi boost. I should have known this but i needed to double check so I wasn't 14psi off.

biggy238
10-31-2016, 07:17 AM
That should be correct, modern 5v sensors use a working range between 0.5 and 4.50 with voltage above or below being "data out of range"
If I can find the graphic today I will post it.

Sent from my Moto X using Tapatalk