View Full Version : Pto shaft movement?
J-Pipes
06-03-2018, 09:34 PM
Finally put an over running clutch on my M today, and with it lengthening the tractor side, the pto shaft only has 3" of movement before fully compressed? Is that enough, or do I need to lengthen the hitch of the tractor a little? It's a bush hog 306 pull type if that matters.https://uploads.tapatalk-cdn.com/20180604/875053362f1eb8d73ed461f339bf3b3d.jpg
Sent from my SAMSUNG-SM-G930A using Tapatalk
Signature600
06-04-2018, 07:22 AM
That should be fine for a pull type...Turn it as sharp as possible and make sure if it gets longer or shorter, but as long is it clears you should be good.
Chris
J-Pipes
06-04-2018, 07:33 AM
Ok, thanks. Plan on dragging it around the yard and watching it, just didn't know if there was a standard rule of thumb or not.
Sent from my SAMSUNG-SM-G930A using Tapatalk
Signature600
06-04-2018, 08:02 AM
Far enough to not hit ...close enough to not come apart.
Chris
vBulletin® v3.8.7, Copyright ©2000-2024, vBulletin Solutions, Inc.