PDA

View Full Version : 24v delivery tubes in CR head

CL2000
12-03-2008, 11:18 PM
I want to use the standard 24v lines on my truck......I will be swapping injectors on a pretty normal.Can I turn the 24v tubes down to the same diameter so they will fit in the cr head?
CL2000
12-07-2008, 05:37 PM
anyone know?
Rods
12-07-2008, 09:07 PM
I think CR tubes are longer and the ends are different than the pre 03 24v lines , I was going to do the same thing
kxhonda
12-07-2008, 11:08 PM
IC-Smoke had some diff tubes made up to use the VP44 lines. Seems like the way to go.
12vdzl
12-11-2008, 01:42 AM
IC-Smoke had some diff tubes made up to use the VP44 lines. Seems like the way to go.

I think the Mike (Monster pump inventor) makes them. It'd be best to Pm smoke to verify.

Good luck
jktcummins
03-11-2009, 04:41 PM
Anything ever come about with this??????
j-rod
03-11-2009, 05:31 PM
Pretty sure its custom lines (Haisley or Scheid) or custom tubes (M&J Tool).
jktcummins
03-11-2009, 06:32 PM
so the thread on the 24valve nut will thread into the CR head???
j-rod
03-11-2009, 08:21 PM
I would guess so - I would guess there is a difference in the tube length, but I never really did a comparison side by side. Maybe will this weekend.
jktcummins
03-11-2009, 08:28 PM
i have both sets of lines so i might check it out also
CL2000
03-12-2009, 12:46 AM
24v lines screw in a cr head.Get lines from Sceid to use cr tubes, it is cheapest route
shiftycapone
03-12-2009, 12:57 AM
Scheid told me like $185 for connector tubes for a cr head while using stock vp lines. I thought this would be easiest.
CL2000
03-12-2009, 12:59 AM
I think he is p-pumping so he will need lines anyways.
IC-Smoke
03-12-2009, 07:41 AM
VP lines WILL screw into a CR head, the few of us that have done a CR head swap that I know are using the crossover tubes.

M&J makes them but sheids, eep, haisley, and M&J sell them

pic:
http://i156.photobucket.com/albums/t16/ICSmoke/100_3047.jpg
JakeDiesel
03-12-2009, 12:44 PM
what is the reason for using 24v tubes over cr tubes?
jktcummins
03-12-2009, 02:15 PM
well the head didnt come with any of the tubes or hold down nuts i a guess it will be easiest to run the tubes that mike makes to run with the .093 vp lines i have now. I am going to try this all out and then probably going p pump but not right now.
lmills
03-19-2009, 10:46 AM
All I can say is make sure you order them well in advance. I purchased a set last week and even over-nighted a check to Mike. Agreed with him that I would include an over-night payment with the check to get the tubes here ASAP. Well, here I am on Thursday, deliveries have came and left and no tubes.