Guess that axle(1st gen axle upgrade)

[pulltilbroke]

Check out what stillsmokin and me are workin on, can you guess what axle it is?

These have been used in gas pull trucks in our area for quite a while with a lot of good results in stock form, This one has been altered quite a bit using parts from another common rear


http://i547.photobucket.com/albums/hh449/pulltilbroke/9.jpg

http://i547.photobucket.com/albums/hh449/pulltilbroke/8.jpg

http://i547.photobucket.com/albums/hh449/pulltilbroke/7.jpg

http://i547.photobucket.com/albums/hh449/pulltilbroke/6.jpg

MMMM Beefy
http://i547.photobucket.com/albums/hh449/pulltilbroke/5.jpg


http://i547.photobucket.com/albums/hh449/pulltilbroke/12.jpg


http://i547.photobucket.com/albums/hh449/pulltilbroke/11.jpg

http://i547.photobucket.com/albums/hh449/pulltilbroke/4.jpg

http://i547.photobucket.com/albums/hh449/pulltilbroke/3.jpg

http://i547.photobucket.com/albums/hh449/pulltilbroke/2.jpg

http://i547.photobucket.com/albums/hh449/pulltilbroke/1.jpg

http://i547.photobucket.com/albums/hh449/pulltilbroke/securedownload.jpg

[DodgeFever]

What you have is a GM eaton used late 40's thru about 1972 excellent rears, only problem I ever had was twisting the course splines pinion & axles. You can change your backing plates and put small brakes & light drum for sled pulling

[pulltilbroke]

Bingo

but this is no ordinary HO72 though

[stillsmokin]

I think pulltilbroke was just wanting to see if people know this axle is out there.

I knew the 17 spline OE axles were a problem, they're retired to the shed, that's not an issue now. I talked to plenty of people in pulling and there were no known pinion spline problems even at 800HP. I chose the small brakes as you mentioned, parts were cheap and easy to obtain.

It's a nice axle to fit into a first gen, VS a 70U. Had to try somthing different, dana 80's just aren't easy to come by locally, especially the way I needed one geared.