No tach or dash problems!

[farmboy3510]

I got the truck in my sig running tonight and I have no dash other than qil pres. and fuel gauge. I bought the Haisley relocation bracket and have the bracket installed correctly. I plugged the sensor back in and nothing. I cleaned the connection and that did not make a difference. I am missing something. I need to go pull on fri. so any help would be greatly helpful. Thanks in advance for the help.

[Tate]

Did you egg out the hole in the case so the sensor is close enough to the cam gear tone ring?

[farmboy3510]

Yeah I milled out the housing just like the directions tell you to.

[CC12V]

Loosen the screw , start the truck , jiggle the senser around. Have someone look at your tach to see if it moves. The sensor is pretty sensitive.....yes I'm a wordsmith.:hehe:

[farmboy3510]

Thanks I'll give that a try and see if it fixes the problem.

[farmboy3510]

I tried loosening the sensor, shaking, twisting and made no difference. I took it out and cleaned it, made no difference either. I checked the sensors resistance and it showed like it was working I guess b/c the readings were changing but I ordered a new one to try to put that in this morning to see if that helps.

[HOSE_B]

is the engine ecu still pluged in checked and two plugs going to the ecu may not be in all the way

[farmboy3510]

I bought a new sensor and that took care of all of my problems. Thanks for the help.