View Full Version : What size is track bar bolt/nut??
BAF250
05-16-2006, 09:15 AM
What size socket is needed to tighten the track bar???:thankyou2:
mikehalseyjr
05-16-2006, 02:42 PM
1-1/16" I think. . .If it is not that, it is very close to that.
Just buy a 3/4" Drive CRAFTSMAN socket set. It will come in handy if you are messing around with Super-Duty suspensions!
wideopen
05-16-2006, 03:30 PM
It's like a 28mm or a 32mm I can't remember ??
BAF250
05-16-2006, 04:07 PM
Thanks,
I think I have a 32mm I will check.:thankyou2:
Bill
sredish
05-16-2006, 04:55 PM
I was thinking 32 as well, but like them, not 100% sure.
mikehalseyjr
05-18-2006, 08:45 AM
I can not believe it came loose.
FMC puts A LOT of loctite on that thing!!!
BAF250
05-18-2006, 08:55 AM
I was told by some that they turned theirs 1/4 to 1/2 turn and it made a big difference. I thought I would try that before going to the Dealer!
Bill
mikehalseyjr
05-18-2006, 09:47 AM
Do you have a "clunk" in the front end or something?
DCSpecial
05-18-2006, 10:43 AM
30mm
vBulletin® v3.8.7, Copyright ©2000-2024, vBulletin Solutions, Inc.