Fabbed up Fabtech traction bars

I had to get the axle mounts widened to fit the 4" axle housing instead of the typical 3.5" housing on the SRW truck (for some stupid reason fabtech doesn't make a kit for the duallies)and then almost had to move my air tank there is a bout 1.5" between the front mount and the air tank ..also it was real close to the effin' cab mount..also had to cut part of the fuel pump mount off to clear the top of the bars and it is still about a 1/2" off the filters..

MAN OH MAN..did it make a difference..no more vibrations.. no more floppy reara end..no more teeth jarring over rough roads..its nice and well worth the money..I wish i had of done them along time ago.

here are some pic of the install and after.

widened bracket


axle brackets




front mounting location before install

see how close

fuel pump bracket FAB work..LOL


yes this is VERY VERY close to brake lines and fuel lines..

not a real good pic but you get the idea of how close everything is

air tank on the left

all done

you can barely see them..thats fine though..I can feel they are there

Looks good

Looks great!!:rockwoot:

Nice fab work!