Competition Diesel.Com -  Bringing The BEST Together

Competition Diesel.Com - Bringing The BEST Together (http://www.competitiondiesel.com/forums/index.php)
-   General Diesel (http://www.competitiondiesel.com/forums/forumdisplay.php?f=171)
-   -   Dana 60 parts (http://www.competitiondiesel.com/forums/showthread.php?t=199117)

bigstacks95 01-26-2018 09:30 PM

Dana 60 parts
 
Dana 60 part out! All prices OBO!

-Warn Severe duty 30 spline locking hubs, used but in good shape $150
-Yukon 4340 Ford F550 35 spline long side inner axle, 38.5" long (also can be used in Dodge trucks as a replacent for the cad shafts with a spool) $200
-OEM Spicer Dana 60 short inner axle shaft from 79 F350 (can also be used as a short side replacement for Dodge) 2 available $100/ea
-OEM Spicer Dana 60 long shaft from 99-04 F350 (Just a C-hair to short to use with the spool but fits fine with welded 35 spine carrier in a Dodge) $100
-Chevy 30 spline outer shafts, 6 available $50/ea
-Chevy 35 spline OEM inner shafts. $100/ea or $150 pair.
-Dodge knuckles with Chevy spindles/hubs/brakes for locking hubs $300/pair
-Dana 60 35 spline spool for 4.10 and lower $60
-brand new Spicer 1480 yoke for Dana 60 $120
-Used Motive brand 5.13 THICK gears standard rotation $100
-Dodge Dana 60 bare housing no knuckles no guts, sway bar brackets have been cut off. Spring pockets perfect $400
-Moog 2nd gen track bar used on pulling truck 1 season, $150
-Chevy Kingpin Dana 60 housing, bare with knuckles, $300
-OEM Dodge coil springs. $50 pair

Done with Dana stuff make an offer and get it out of my hair. Prices do not include shipping. Paypal accepted. Can ship via UPS. Pic for attention

bigstacks95 01-29-2018 09:37 PM

Bump, make offers

getblown5.9 02-04-2018 03:15 PM

Any pics of the dodge knuckles with chevy spindles etc? What else would be needed for the conversion to locking hubs?

bigstacks95 02-05-2018 07:00 PM

Quote:

Originally Posted by getblown5.9 (Post 2654887)
Any pics of the dodge knuckles with chevy spindles etc? What else would be needed for the conversion to locking hubs?

If you PM me your number I can send you pics. Its a Chevy spindle and caliper bracket re-drilled to the 4 bolt pattern for the dodge knuckles. You also have to trim a good section of the Dodge knuckle off. Pretty straight forward.


All times are GMT -5. The time now is 06:50 AM.

Powered by vBulletin
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2006 - 2024, CompetitionDiesel.com
all information found on this site is property of www.competitiondiesel.com