2wd Pro street truck
 

Have a customer looking for a roller it's close to completed or something it has jump on the Chassis work. 4 linked 3rd or 4th gen. Pm me what you have or any leads to one.

I seen a 2nd gen 2wd with cage, rear, caltracs, slicks and all in Florida on Craigslist, I believe in Jacksonville. For 5,000$. Said it went high 9's straight as an arrow.


Sent from my iPhone using Tapatalk

If it's white it's my old truck, would 60ft 1.48 and lift the left front tire 4"s. Never technically ran a 9 cause the local track was 8th mile but ran 6.50's at best.

Yep that's it. I think it was posted in Jacksonville.


Sent from my iPhone using Tapatalk

It's located in Middleburg, sold it to a buddy as a roller and he never did anything with it.

Nice, who set it up to hook? Custom work?


Sent from my iPhone using Tapatalk

A chit load of trial and effort by me, the 60ft was no problem with the truck, it's when I tried to start putting some decent power to it down track. Would only hold so much after the conv locked down track. Bought a pro street 4×4 roller and swapped my engine/trans. The little truck runs 10.50's without breaking a sweat.

Theres a nice second gen roller on here I just saw yesterday for 6500 I think

Sent from my SM-N910V using Tapatalk

It's Vaoutlaw that has it listed for 7500, straight up seller, that's who I bought my 4×4 roller from.

I have a 97 1500 2wd shortbed...4 link with a AAM 11.5 narrowed, caged...have spool, 3.42 gears, 3 sets of slicks, front rubber and some other stuff, but needs all put together. Lost time for it...if it sounds interesting, pm me...

http://www.competitiondiesel.com/for...pictureid=3489

Chris

I like that stance right there.

Needs some springs in the back yet, but it's lowered all the way around.

Chris

Bump still looking.