05 CR oil feed line
In the process of a 2nd gen swap on my 05 and will be making the feed and drain lines for the turbo. I'm using 6AN braided on the feed. I have both a M12 - 6AN and a 1/4NPT - 6AN fitting for the filter housing side of the feed. My question is will the M12 - 6AN fitting be sufficient OR should I drill and tap the housing to accept the 1/4 - 6AN? Both fitting I.D's are within a 32nd of each other. Thanks
Sent from my SAMSUNG-SM-G935A using Tapatalk |
I'm using the M12 fitting, no problems here.
Sent from my iPhone using Tapatalk |
Good to hear.....i could drill and tap for the 1/4NPT but if the M12 will feed enough, I'd rather not
Sent from my SAMSUNG-SM-G935A using Tapatalk |
All times are GMT -5. The time now is 04:41 AM. |
Powered by vBulletin
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2006 - 2024, CompetitionDiesel.com
all information found on this site is property of www.competitiondiesel.com