Welding positioners.
My M&K products unit quit on me for a second time so I bit the bullet and bought another(larger) unit. Place back east called All-fab. Larger unit with muck heavier grounding capability. Got about 10 years out of the M&K unit so if I can get at least that much out of the new one I'll be fine.
|
1 Attachment(s)
Takes a bit of getting used to with it being so much taller, but it seems to work well.
|
Welding positioners.
Slick looking positioner Ron.
Did this one come with a foot petal also? |
Yes it did. Along with a 3 jaw chuck for larger parts.
|
Quote:
Quote:
Sweet setup Ron! |
I thought about moving my fancy splatter shield before taking the picture. I had it, I used it. :hehe:
|
Look up L J Welding & Machine. We have a 12P-900 and has been flawless
|
I use a RTJ ring welded to a piece of 1-1/2" pipe, greased up and slid into a piece of 2" pipe. Weld a flange bolt across the 2" with nuts on each side welded down to the table. One nut welded to the front of the 2" with a bolt run to the table to ajust pitch...
Works like a charm, and it's free ! But then, I'm a cheap SOB. |
Quote:
|
All times are GMT -5. The time now is 05:41 PM. |
Powered by vBulletin
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2006 - 2024, CompetitionDiesel.com
all information found on this site is property of www.competitiondiesel.com