MaxSpool power to 6000 RPM's Congratulation John Weatherby
 

This is one of my MaxSpool Pro Grinds . No other Cam even come close in high rpm power


https://www.facebook.com/photo.php?v=157906217733571

we have high RPM grings in Billet 8620 and Cast. We also have them in 55mm and 57 mm mains with lobe lifts up to .435

this cam is becoming popular , I spool up 10 8620 steel UGL billets at a time , 5 are spoken for if you need one the lead time is 4 to 6 weeks after these 10 are ground

High rpms is right This 6k rpm cam is for sale!!!!

:pop:

Sounds like it had no bottom end? Any video from other end of the track?

from phone

Ding ding ding!

I've got videos on Facebook. John Weatherby. Running 4hi 2nd gear. 4.88s and 35s

Needs more torque......

why not 5th 4 low? with 4hi 2nd you need to turn 6k to get any wheel speed

We've try'd 5th 4lo over and over. I've got videos some where. As soon as I come off the clutch it falls on its face. Barely gets off the line in direct It's still snuffing in 2nd on the big end Anything below 4800rpm or so it falls off hard

2nd hi with 4.88s is like a 16.0 final ratio. Still falls on its face? Yikes

Josh the videos on fb are 2nd 4hi. Wait hits and it falls off fast!

I wonder why it falls on its face after 4800...

Turbo gasping for air and only making hot charge air?

We've been told to much over lap and so on is causing it. Another truck has done some testing that led to all this

I am surely not an expert in cams but it would seem to me that high amounts of overlap probably aren't the best for a limited air situation.

School me otherwise, eh.

Is the truck in the video a 2.6 truck?

Yes sir it's a 2.6 truck.

Whose HX60? What turbine housing?

EDs hx60. 32cm housing