I have a Question too...
Please clarify:
When using a JGS 40mm wastegate in a COMPOUND turbo setup... Before adding the gate, I had seen over 100 psi drive pressure to the secondary, (smaller turbo) And 50 psi to the primary turbo. I have installed the heavy spring, (~10 psi) I have installed a pressure regulator on the compressor discharge of the secondary turbo, and have it set to 5 psi. The bottom port is open to atmosphere. (Has a short length of open ended tubing on it, so no water gets inside the actuator housing.) Is this correct? |
I run a 50mm JGS gate with a particulate trap and run drive pressure to the top and run boost regulated to 15psi to the bottom and tune from there.
|
I'm gonna try that.
I've already got the filtered drive pressure gauge, so may as well use it. Thanks! |
All times are GMT -5. The time now is 06:26 AM. |
Powered by vBulletin
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2006 - 2024, CompetitionDiesel.com
all information found on this site is property of www.competitiondiesel.com