B&M transmission pan for 47re

[SuperDave4x4]

Has anyone installed one of these on a 47re? I went to install mine today and it wouldn't fit. Bolt pattern is correct but the valve body comes in contact with the side of the pan at the rear causing the bolts holes to become misaligned.

Just wondering if anyone else has had this problem.

 

[Ackerdiesel]

Got one on my 48. May b a lil different but had no issues with the install.


Ryan

 

[C'ya]

We occasionally run into fitment issues. Have to do some minor grinding to the ribs on the back left side of the pan and occasionally on the sides too. It sucks we've tried to content then about it but it seems they are impossible to contact

 

[SuperDave4x4]

We occasionally run into fitment issues. Have to do some minor grinding to the ribs on the back left side of the pan and occasionally on the sides too. It sucks we've tried to content then about it but it seems they are impossible to contact

Yup. Those are the exact spots it hits. I went out and ground them down and installed the pan. Had to test fit it 3 times and grind but eventually it went on. Thanks C'ya