has any one bent push rods yet
 

the only reason i am asking is that my buddy bent 16 push rods a couple of weeks ago when he was pulling he thinks he found the cause but i just want info if guys have bent push rods in these new engines

hes making over 500hp pretty sure of that hes running one programmer cant think of the name

any ways the truck runs dang good

Yes. There have been a few cases of this on the org.

Is this Eric you speak of?

I've heard of very few cases of bent pushrods in the 6.0L or 6.4L(low single digits in the past 7 years of the motor being released.) My 6.0L is pushing every bit of 1000rwhp and so is Shawn Ellerton's, both with stock pushrods. If there is a pushrod issue, it's a mechanical failure. 500rwhp definitely isn't overpowering the stock components.

I've heard of a handful over on the ORG, but it seemed to be from over-rev on they dyno in most cases.

yes
forgot about this post :bang