Cflanery88
New member
Cause I coated the center section(cartridge) and it was the easiest way to get to sit in there without it sitting on the turbine wheel or compressor wheel.
6.4L Cummins Build Complete and awesome.
- Thread starter Cflanery88
- Start date
Cause I coated the center section(cartridge) and it was the easiest way to get to sit in there without it sitting on the turbine wheel or compressor wheel.
straight 6 roar
New member
When you say exergy make you some lines what do you mean? My buddy is looking for a better solution on the feed for a 5.9 rail and 6.7 pump.
Cflanery88
New member
Exergy can make custom lines. They need templates out of 5/16" od brake lines with the following requirements
-Minimum 1 3/4" from end of line to start of bend.
-Minimum 1 3/4" in between bends.
-1 inch bend radius required.
I was told they do have a shortage of line so I would contact them first before going buck wild making a template. They also have fittings of many sorts if needed.
Cflanery88
New member
Intermediate shaft and rebuilt kit should be ordered this week and should have everything to get the trans back together.
Sent from my iPhone using Tapatalk
Cflanery88
New member
Hopefully sell my DPC triple disc to go to a quad disc and Machine my gear train for roller Torrington bearings in the coming weeks. The case goes out for powder coat tomorrow hopefully.
Sent from my iPhone using Tapatalk
Sent from my iPhone using Tapatalk
Cflanery88
New member
The HUBB filter and cleaning station came today and hoping it’s as efficient and works as good as it looks.
Sent from my iPhone using Tapatalk
Cflanery88
New member
Sure is. Says so right on it lmao. If you use there ultrasonic cleaning station and cleaning solution to clean the filter they warranty it for 100k miles if Interpreted what I read on it correctly.
Cflanery88
New member
DPC Billet Quad disc showed up today. Really have to hand it to Phil I didn’t expect it so quickly. Called last Friday and he had it ready and shipped out Monday.
Sent from my iPhone using Tapatalk
Sent from my iPhone using Tapatalk
Red Sleeper
Active member
Phil is the man, hands down.
Nice shirts.
Nice shirts.
ramthiscummins
New member
DPC Billet Quad disc showed up today. Really have to hand it to Phil I didn’t expect it so quickly. Called last Friday and he had it ready and shipped out Monday.
Sent from my iPhone using Tapatalk
So everything is ready to go then. Fire it up yet? How does it drive? Spools good? LOL
1320Cummins
2G Collector
Educate me on the Swiss cheesed sun shell. Will it withstand the torque?
Whats the scoop on the OD direct spring, anything special or just a standard replacement?
Whats the scoop on the OD direct spring, anything special or just a standard replacement?
Cflanery88
New member
The “Swiss cheese” reaction Shell is a light weight Billet steel and stronger than the factory one.
Ultralight Billet Reaction Shell
The overdrive direct spring is a Mega spring, basically a tad larger/ longer as to have more tension/pressure.
#D12970A SPRING
1320Cummins
2G Collector
My thoughts exactly... Suncoast must have hired ATS marketing directors cousin :bang
QMFB
Fastest Welder in Texas
Not saying it's not stronger, or lighter than stock... But I see tell tells that say it's not "billet".
Cflanery88
New member
Yeah I had the same argument on PDD’s “Billet” Belleville spring. Pretty sure it’s the same stamped lightweight reaction shell TCS offers just with a couple more holes cut in it.