Drive shaft question
I bought a truck recently it looks to be lifted 3-4 inches the drive shaft is bent and is causing vibrations and cause the transfer case to mess up so i bought a used drive shaft from im guessing a stock truck when i go to lengthen the drive shaft should it be a tight fit from transfer case to axle or should there be like an inch of space? Hopefully u guys can understand I'm really bad at writing things
|
There's 3inches from the ends of both driveshaft and axle where they would meet. And that's with drive shaft all the way in the transfer case
|
All times are GMT -5. The time now is 04:11 AM. |
Powered by vBulletin
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2006 - 2024, CompetitionDiesel.com
all information found on this site is property of www.competitiondiesel.com