48 swap from g56
I’m sure there’s a million threads on this, bought a suncoast mega 48. (Stage 3). Comes with crossmember, Firepunk anteater, auto valvebody, adapter plate. I’m pulling g56. What all will I need to finish this? List is this :
Trans cooler Auto shift Column w harness (factory) or can I have auto valve body w bm floor shifter incase I swap to manual vb later? Shorten t case shaft Drive shafts lengthen or short? One piece rear in 2012 4 door long bed? Thanks |
Suncoast sold you a Firepunk anteater?
Did the same swap except I’m a 3rd gen. Don’t try to source everything you need for a column shift that would be a hassle. Find a shifter that works for a torqueflite 727 and your gtg. Which valvebody do you have exactly...because if it’s not PCS or mvb it won’t work. Other than that your list looks mostly complete, I would also recommend a 6.7 fluid cooler if you don’t already have plans for one. A few compression fittings and your good! Good luck man! |
I probably have the column stuff you would need from left over g56 swaps I’ve done.
|
Quote:
|
What did you do with g56?
|
Quote:
|
Quote:
|
All times are GMT -5. The time now is 09:23 AM. |
Powered by vBulletin
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2006 - 2024, CompetitionDiesel.com
all information found on this site is property of www.competitiondiesel.com