OK. So question of the day, and it's going to highlight the obvious.
I haven't degreed my cam. I'm going to have to.
Anyway, I'm checking piston to valve clearance with a dial indicator. (head is already installed)
I set TDC with a dial indicator through the injector bore.
Checking PTV with the dial indicator on intake #1, I have 0.115". 0.100" valve reliefs.
My question is, there is 0.015" piston to head clearance?
I know I should have checked all this before hand, but I was being a dick.
Sent from my XT1575 using Tapatalk
__________________
Check out @bdmaximusworx
05.5 Campanella White TDi Jetta 5spd 45.5MPG
-Little Sexy
'10 Silver F250 CCLB 4X4 6.4L cummins Swapped
Insta @trash.panda250
|