Well I decided to find the miss I had. After a good set of injectors, I still had a miss on the rear 3 cylinders. Decided to yank the head and found a very rough set of cylinders.
ImageUploadedByTapatalk1421026974.834537.jpg
I did manage to get lucky and the bores measured good and I had some meat left. I got the hone out and was able to cut the #1. All still measured good.
ImageUploadedByTapatalk1421027065.340694.jpg I will have to pull all of the pistons and cut all bores. I dropped the pan and some mains and cut the filter. The filter was bad but have seen worse.
ImageUploadedByTapatalk1421027482.718153.jpg. The mains were ok but it will be getting rods,mains, oil cooler, new rings and the bores cut. Head will also be getting swapped with my spare. The 160 pump was also exchanged for a 215 pump. Had to button it up and get it out of the shop till I get parts. Good weekend so far.
ImageUploadedByTapatalk1421027701.634208.jpgImageUploadedByTapatalk1421027710.969817.jpgImageUploadedByTapatalk1421027718.485826.jpgImageUploadedByTapatalk1421027741.422398.jpg