I am interested in getting a set of the Extreme Studs for my 3rd gen. Was hoping to do a replacement 1 at a time with the bolts starting at the center bolts as the pattern dictates. I had found a few posts and beleive this was done over several steps.
1st - replace one at a time to 100lbs
2nd - bring them up to 120lbs
3rd - bring them up to 140lbs
Is anyone aware if any other steps are need for clearance on a 3rd gen? I am looking to do this over a weekend in my garage if at all possible.
Thanks
__________________
2004.5 SRW 2500 4x4 48RE 3.73LS
|