[Cozze44]

Been a while for an update so here it goes:

I have my setup pretty much finalized, meaning I have spent more money then I really ever thought I would on this heap. Got a whole bunch of real nice parts all palletized and heading out to UCF Machine in Carlisle. Plans for machine work are as follows:

Drill and tap for 14mm mains
Line hone mains w/ girdle and billet caps
Punch out block for Cam bearings
Torque plate hone cylinders
Remove intake shelf, drill and tap for side draft intake
Full port job
Delip new SOVP pistons and cut reliefs as needed
Balance rotating assy

Also decided to have them assemble long block. I assembled my own last engine build, but I don't have the proper tooling to properly check clearances, so i'd have more confidence having them do so. Any other suggestions as to work it should have done wil torn while at the shop?