Quote:
Originally Posted by prostockpuller
Have a 5/8" thick spacer made to fit between the bell and the spacer on the cummins block. Any shop with a Water jet or laser can do this fairly cheaply. Mine was Aluminum.
RK
|
Sticking with my three disc clutch that would require me getting a longer input shaft on the reverser I already have. I believe the spacer will be necessary and a longer input shaft if I decide to go to for disc.
Just trying to offset the cost of the Stroud blanket. When I sold my last truck the blanket went with it. The blanket is over half the cost of the Bell so I would rather go with the Bell if it's not too big of a PIA.