Quote:
Originally Posted by getblown5.9
so this will be a heavy duty cover with the trusses built into it?
|
the girdle plate will be similar to the one that "BigYellowIron" posted only the instead of havine cut outs around the holes for the bolts that go into the housing it will be a complete round piece so it will be more rigid
It will also have a 2" bung in the center so u can inspect the ring gear without removing the whole thing
Cost will be under $300 delivered to your door
The model with extra bracing that goes out to the axle tubes I am not sure about yet
Quote:
Originally Posted by 01PPUMP
This is a good idea, I just made myself one that ties into the bearing cap bolts which are now studs and also has snubber bolts to keep pressure on the caps.
|
I like your idea of snubber bolts