[Big Blue24]

Transgo 48re shift kit page 5



Remove the 3/4 accumulator body, (3) T-25 screws.




Drill through with the kit supplied drill bit.







Remove the (5) T-25 screws to remove the cover plate and gain access to the 3-4 accumulator piston. Remove the stock spring (sometimes it's broke in half) and install (3) new red springs provided in the kit. It is difficult to replace the cover with the higher spring pressure from the new springs. I also replaced the teflon seals on the accumulator piston with new seals provided in the master transmission rebuild kit. These seals rarely fail, but get replaced during a major overhaul/rebuild.









Install the kit supplied plugs flush or just deeper than flush:









Finally reinstall the 3/4 accumulator assembly with the kit supplied tranfer plate sandwiched between.