Competition Diesel.Com - Bringing The BEST Together - View Single Post

biggy238 · 09-08-2017, 08:49 PM

You guys pretty much hit on the two means all of us in the shop arrived at. Interference fit or ream and sealant. I don't forsee a need to remove it. I have an induction heater and liquid nitrogen. I would **** a brick if that poly line became brittle and snapped though.

I should have snapped a picture of the recess in the block. That collar on the tube won't fit down into it far enough to flush. I will get a picture tomorrow.

All of my freeze plugs have retaining compound on them.

Sent from my XT1575 using Tapatalk

09-08-2017, 08:49 PM	#5
biggy238 Name: biggy238 Title: Too Much Time Status: Not Here Join Date: Aug 2008 Location: Just North of Wrong Member`s Gallery Posts: 10,862	You guys pretty much hit on the two means all of us in the shop arrived at. Interference fit or ream and sealant. I don't forsee a need to remove it. I have an induction heater and liquid nitrogen. I would **** a brick if that poly line became brittle and snapped though. I should have snapped a picture of the recess in the block. That collar on the tube won't fit down into it far enough to flush. I will get a picture tomorrow. All of my freeze plugs have retaining compound on them. Sent from my XT1575 using Tapatalk __________________ Check out @bdmaximusworx 05.5 Campanella White TDi Jetta 5spd 45.5MPG -Little Sexy '10 Silver F250 CCLB 4X4 6.4L cummins Swapped Insta @trash.panda250 Last edited by biggy238; 09-08-2017 at 08:51 PM.