Found a dana 60 local that has 3.54. This will be going in a half ton 1967 shortbed chevy. Truck will weigh roughly 5k and will be on the street as much as the track. Planning to have any axle narrowed with 40 spline axles an 9'' big bearing ends.
9'': will need upgraded everything, everywhere(couple of posts on here say it needs "pro" gears)
dana 60: Vmax, and a fast yellow dodge made it work, spools and limited slips are resonable
dana 70: heavier, expensive parts, stronger
I don't know 14 bolts, sterlings, aam
Where do You spend Your money?
Good article comparing the 9'' and the dana 60
Chevy Chevelle Rear Axle Swap - The Great Rear Axle Comparo - Hot Rod Network
9'': will need upgraded everything, everywhere(couple of posts on here say it needs "pro" gears)
dana 60: Vmax, and a fast yellow dodge made it work, spools and limited slips are resonable
dana 70: heavier, expensive parts, stronger
I don't know 14 bolts, sterlings, aam
Where do You spend Your money?
Good article comparing the 9'' and the dana 60
Chevy Chevelle Rear Axle Swap - The Great Rear Axle Comparo - Hot Rod Network