|
I like that cam its very aggressive to have that much lift on that short a duration so your doing the right thing running bigger tappets. The lsa is a 106 thats a bit tight so valve clearance may be tight. I would check it for sure its hard to say if its going to work or not with out checking. If u adjust your valves to zero lash and then open them another .020 - .040" turn the motor over if it spins you should be ok. I personally like to check every cam i install with a degree wheel and pay close attention to valve timing events but the above method should work to be sure u have some clearance you want at very least .030-.040" ptv with lash.
|