My P24V build
Since I'm sorta on the subject of injectors...
As I mentioned, the 62/475 has begun to bore me, and have been beating my head against the wall as to what I want to step up to. I think I've come to the conclusion that I'll just go with a basic 64/480 setup, mostly because anything bigger than a 480, from what I can find, is custom machined and pulls a premium, even though is essentially a bigger inducer, with the same exducer, shoved into the same housing, so I'm not exactly sure if the gains warrant the extra cost. I know a 64/480 isn't going to put down mind blowing quadruple digit power, but I have a angle grinder and a torch to remedy that.
Anyways, asking the peanut gallery here. Say a Sxe 64.5/73/.91 with a 50mm gate at the manifold, over a fmw 80/96/1.32 with the .66 (I think? John Deere cover, the good one.) ar housing, what would be a good 6 hole injector to pair with that.
Not concerned about "well this injector will support this much, etc", I want to know what size would work best with the volume of air that this particular setup brings to the table.
Sent from my iPhone using Tapatalk
__________________
P24V, Billet 62/68/14, Billet 475/96/1.32, 27°, Seth's Stg 3 @ 450cc, dual feed, DFI 7x12, Fass240, 110#, 425, p&p/3 angle/oring, ED freeze plugs, BD IC, VP MAX boots, stainless mani, Snow w/m, coolant bypass, CTS2, EAS, POS NV4500, valair quiet dual ceramic
Last edited by Financial Mistake; 06-28-2017 at 07:27 PM.
|