Quote:
Originally Posted by khaoskustoms
The new race truck build I did has a Hamilton solid 6.7 block, 5.9 crank, carrilo long rods, 6.7 pistons, girdled, bigger cam then yours, ported head, side draft, similar sized injectors with two 12mm stroker pumps. Turbos are an older Fleece 71/83 T4 with a 1.1 housing over a SXE594 with a 1.45 T6 housing. One 60mm wastegate on the exhaust manifold and one 60mm gate on the hot pipe. 06 ecm with tuning by Starlite. 2500 rpm converter and the turbos spool extremely quick. 20psi at 2500 in under about 3 seconds. Made 1500hp at the tire on my chassis dyno. Our first and only full 1/4 mile pass was a 9.43 @ 145mph. That was on our 1300hp tune.
|
This sounds like a nice spooling setup, and the e/t and mph are enviable, but that e/t and mph at 5,500lbs puts it at just under 1,100 hp on the
CompD hp calculator.