Competition Diesel.Com - Bringing The BEST Together - View Single Post

biggy238 · 10-17-2018, 08:00 PM

NP273F on the left, NP273D 23 spline on the right.

So the pocket bearing depth on the 273D needs to be adjusted. The D is 10mm deeper that the F, and it won't support the end of the main shaft at 10mm.
I used my GP 19mm extra deep socket, and a socket large enough to safely press the input shaft to adjust the bearing and cup plug.

10-17-2018, 08:00 PM	#126
biggy238 Name: biggy238 Title: Too Much Time Status: Not Here Join Date: Aug 2008 Location: Just North of Wrong Member`s Gallery Posts: 10,859	NP273F on the left, NP273D 23 spline on the right. So the pocket bearing depth on the 273D needs to be adjusted. The D is 10mm deeper that the F, and it won't support the end of the main shaft at 10mm. I used my GP 19mm extra deep socket, and a socket large enough to safely press the input shaft to adjust the bearing and cup plug. __________________ Check out @bdmaximusworx 05.5 Campanella White TDi Jetta 5spd 45.5MPG -Little Sexy '10 Silver F250 CCLB 4X4 6.4L cummins Swapped Insta @trash.panda250 Last edited by biggy238; 10-17-2018 at 08:06 PM.