Quote:
Originally Posted by TheBac
You did good. Thats how shops cut Dmax pistons, for the same reasons you did. What size radius did you put on the edge?
|
I gave it the eye ball radius 
I’m no machinist by any means, but I’m slowly learning. The grinder I use has no degree marks so cut them by eye with the regular tool I was using. Then I cleaned them up with some rough sandpaper and finished them with some rough scotch brite (red pads?). I couldn’t get my tool to give me the surface finish I wanted, but it did the job. Need to upgrade my tooling
__________________
’82 300D benz Bosch MW turned up, HX30, W/A Intercooler
MF Super 90 various odds and ends done. Farm stocker
MF 98 3-71 screaming jimmy. Needs N90's. Another farm stock
'14 Ram Anarchy EFI, G56
|