w/m nozzle

What is their droplet size?

Impingement pins aren't the best choice for airflow or consistency (think spark plug ground electrodes), and stainless is preferable.
 
they seem like overkill for application. they should flow some big amounts of water if there ever being used together. im having a custom intake crossover made that will be plumbed with two 1/8th in bungs. one for w/m and one for a little gogo juice
 
XLR8R said:
What is their droplet size?

Impingement pins aren't the best choice for airflow or consistency (think spark plug ground electrodes), and stainless is preferable.
Click to expand...

Hmmm... McMaster-Carr used to list their rated droplet size, now they don't. I'll email them. Good news is that they're now good to 3000 PSI instead of 1000 PSI. :rolleyes:

Think that the air flow restriction of a 1/4" long 1/16" diameter wire is going to be that noticeable on the average oversized aftermarket intake horn?
 
About the size of three dimes glued together.

Compare to grid heaters... :pop:
(Or those big goofy nitrous jets, for that matter. They have around the same cross-section as a NOS Fogger.)
 
Last edited:
You must log in or register to reply here.
Back
Top