6.4L Cummins Build Complete and awesome.

b1c51f1a721271dad15406fc4d243485.jpg
1809cbd189226855142cc3b14a04428b.jpg



Sent from my iPhone using Tapatalk
 
c04c89e58ca6cadd3d5ab4a831a5d11f.jpg

My son is always in the garage and at 4yrs old knows how to use a wrench, and a ratchet and which way to tighten or loosen a bolt lol.


Sent from my iPhone using Tapatalk
 
a98b3b7157006dff33889c5bf0c163c5.jpg

I blocked off the original lift pump hole for the crankcase to valve cover drain/breather and rerouted it to the front oil dipstick port by tapping it to 1/8"npt and a couple fittings.


Sent from my iPhone using Tapatalk
 
0d3939f8830af8dcc7a34e30e713af3f.jpg

1d199794681fb75707b1f5ced787cbb6.jpg

Three generations of water pumps I decided to go with the 2nd gen pump all the way to the right. Bolt pattern and sealing is all the same.


Sent from my iPhone using Tapatalk
 
Last edited:
cdbd544d5701657db15dace83780243b.jpg
f508f0199ece2c06c39cb7a2f0d07103.jpg
3e0b26bfd1535d20731b96d6ff33b8ea.jpg

I did buy an actual ring filer after trashing a set of rings trying to do them by hand with a file but found this to be the quickest and easiest way to do it lmao.


Sent from my iPhone using Tapatalk
 
You must log in or register to reply here.
Back
Top