From mathews8pt on another site. This was his parts list for his swap. Should help a few people out when tracking down parts!!!!
175 pump, gear, nut, washer, all throttle linkage on side of pump, 12v throttle cable, gear case, gear cover, bracket for mounting pump, oil line, T fitting for oil lines
12v TV cable for tranny, TPS mounting bracket and 6 used TPS sensors(not needed if you have a 5 speed) > $50
.084 conversion lines (lines only) > $380
Intake spacer made by local machinist (had him make it 1 1/4" tall)
Cam (max spool 2.5)
Tappets (new
CR tappets) > $90
.022 dvs > $150
4gsk > $130
Fuel lines(just used 3/8" for now, will upgrade later) > $10
Gasket material for intake spacer(i can make about 30 out of one roll) > $6
EOS oil and cummins assembly lube > $10
Timing cover gasket set > $52
Dowel rods (1/2")
110# valve springs
60psi fuel gauge mounted in regulator
Now there are a few upgrades, like the cam and
CR tappets, that arent exactly needed, but its a pretty simple run down!!!