Suspension blocks and pinion angle
So far this season I have been running 2" blocks in my truck and I want to take them out to lower the back down to stock. My question is, is my blocks are tapered 1/4" from end to end making the rear end point more towards the ground making the pinion angle, if I take them out should a run a wedge to keep that angle or don't worry about it? Idk what kind of pinion angles you guys are running or what not so I'm a little curious.
__________________
S&B CAI, MBRP intercooler tubes, PPE manifolds and up-pipes, profab turbo horn, MBRP downpipe, 5" straight exhaust, 10mm cp3, Fass 150 lift pump, 60% over injectors, studs, Custom traction bars, G2 tie rods, kryptonite center link, built trans & T-case
|