[Cflanery88]

I just started mine a couple weeks ago and I used The Driven assembly grease for assembly as well. I also purchased 15w40 break in oil from driven along with 2 bottles of Hamilton cams zink additive and a bottle of Lucas break in zink additive. According to Lucas one bottle of zinc additive treats 4-4.5 quarts of oil so you need 3 of them. I prefilled the oil filter and we pressure lubed about 6 quarts into the engine and dumped the rest in. With pressure tank hooked up and injection harness unplugged we turned it over till oil came out the rockers. Then we unhooked the tank and fired it up bringing the engine rpm up to 1300-1500 immediately for 5min(Hamilton Cams Cam break in procedure). Then adjusted valve lash after engine cooled down. Then went out and beat the piss out of it.

My first oil change I did at 500 miles with rotella T6(had some in the garage) and 3 bottles of Lucas zinc additive. I plan on switching to Brad Penn after I change the oil at 1500miles and continue with the zinc additive treatment.