spdgofast
TOO MANY IRONS
I have a Gear Vendors Overdrive unit mated up to a 271D transfer case out of a 2005 Dodge Ram. This entire setup will fit in 1994 thru 2007 Dodge Ram pickups. It may fit even later models but I'm not sure, basically any Dodge truck with a 271 or 273 transfer case or 47RH 47RE 48RE transmissions. Presently I have it in my 1995 Dodge 3500 12 valve. I have built a cross member with a GM 3500 driveshaft center support bearing to mount at the rear tail shaft housing of the Gear Vendors OD unit to support the OD unit, I didn't like the way that Gear Vendors just bolts the unit to the transfer case with no other support which is another reason I used the 271D T case, its case design I think is much stronger than the 241DHD transfer case housings. The OD unit probably has 2000 miles of use and only probably 500 miles of that engaged in Overdrive. The transfer case came out of a crashed 05 Dodge 2500 which had 7000 miles on it when I bought it.This unit is still in my truck so it can be test driven if someone wants to. I am located in Ft Pierce Fl. 34982 so that's where I would be shipping it from if shipping is required, buyer is responsible for shipping charges. The entire unit is in perfect condition and the only reason I am selling it is because I am selling the truck and I want to sell it separately. I want $2500.00 for the entire setup with the computer and all switches included to install. The part number for this setup excluding the T-Case on GEAR VENDORS website is P/N 3D0272A and costs $3295.00 for just the OD unit.
