madmikeismad
So mad
I have a Transgo Shift Kit laying around if anyone wants one cheap.
Just the shift kit, or a build kit?
I have a Transgo Shift Kit laying around if anyone wants one cheap.
in this picture theres a hole that the pic tool is pointing at ... i have seen some of these with a smaller hole or insert installed ... what does this do to the tranny with this hole being smaller ?????
anyone know anything bout dtt shift kit
For those of you with more experience than me...when you check all the end play specs are you doing it with the frictions wet or dry? I don't know if the frictions "soak" up fluid or not, but with a large stack of frictions and steels the fluid in between them could make a few thousandths difference IMO...
I have the ATSG manual and plan to reassemble my transmission this weekend, but I either read over or couldn't find this info anywhere...
Thanks in advance!
you talking about individual clutch packs? FSM (and everyone else) states to soak clutches before installation, so I would go that route.
As for the input shaft endplay - or the other two selectable thickness bearings - shouldnt make a difference. (the clearance stack-ups dont really rely on the clutch pack assemblies)
They are essentially the same!
Teflon