Quote:
Originally Posted by 97rada
What do you do for rockers?
|
Cut the spot welds out with a spot weld cutter and replace from front fender back to the cab corner. A seam is inevitable on those. There is only one welded seam that is difficult to get to which is on the pillar behind the door. The rest is spot welded. Lots of seam sealer where the rocker and cab corner meet. The use the access holes of the rocker and cab corner to spray inner frame coating into it. Then seam seal anywhere water or salt could get in. This has worked extremely well so far on 4 2nd gen dodges. First one was 6 years ago. That truck was wrecked this spring and everything was still rust free at the seams.
Frame coating:
http://www.eastwood.com/internal-fra...bpUaAgHS8P8HAQ