|
I use a RTJ ring welded to a piece of 1-1/2" pipe, greased up and slid into a piece of 2" pipe. Weld a flange bolt across the 2" with nuts on each side welded down to the table. One nut welded to the front of the 2" with a bolt run to the table to ajust pitch...
Works like a charm, and it's free !
But then, I'm a cheap SOB.
__________________
04 CCLB DRW - 6.4 Cummins, HPTuners, 80% S&S, 10mm S&S CP3, AD165, s464 /s475, full billet 48re, Arp's EVERYWHERE, mild head work, lots of time and money... And never done.
|