Quote:
Originally Posted by Blue streak
factory 2006 ram intake air temp sensor data logged with edge CTS2
single injection nozzle in top rear port on a banks monster ram intake horn
dead head pump pressure set at 250-275 psi
iv never flow tested it at simulated pressures
nozzle is rated by banks at 883 cc/min at 100 psi
|
The operating pressure is going to be much lower. You also are likely seeing a false temp with the nozzle that close. You will see the best
IAT reduction by putting the nozzle the furthest from the cylinder. I do believe you are seeing gains though.