View Single Post
Old 10-26-2017, 02:51 PM   #21

Name: Lance
Title: Loner
Status: Not Here
Join Date: Nov 2007
Location: Albuquerque
Member`s Gallery
Posts: 293
So when doing O-rings, what is a good technique for putting the wire in? I saw a few posts that said tap it in with a brass or plastic mallet, but where the two ends come together, how much of a gap is too much? and is there such a thing as too little of a gap?
95 2500, 100 plate, 3800 washer mod, BHAF, Auto meter, TC lockup switch, Goerend trans, New Era 435s, water/meth, 6 inch lift, DT track bar, Irok Radial 41s with Staun beadlocks, Atlas springs, 4.10s, Detroit in rear, Lock right in the front
  Reply With Quote