I have finally gotten over the majority of the deck build, so now I am getting some time to do some work on my fummins project.
Anyways, yesterday I went to disassemble the rear 2wd overdrive section of the 46rh. I took out the speedometer housing, removed the output yoke, took the small ring out, removed the clutches, took the wave ring out, took the other snap ring out, then I set it up on a block of wood, went to unclip the gear retaining snap ring and the gear train literally moved about a 1/10 of an inch. I just can't get the gear train free from the housing. I even pushed it back up inside a few times and expanded the ring again to see what all was moving. I even did small taps with a rubber mallet and tried pushing really hard. It just won't move. I don't know if it is related, but there seems to be a ticking noise when I rotate the gear assembly.
Now, three days ago, I took my 4wd overdrive housing apart on the 47rh and did the exact same thing, minus the speedo of course, and when I set it up right and then expanded the snap ring, the gear train came right on out with a nice thud.
Am I missing something on the 2wd section or is there something broken and stuck?
My manual is an ATSG. I did ask this same question on another forum and figured why not ask here as well.
Sent from my S60 using Tapatalk